Advertisement
Privacy Stand™
1.
Attach stand-off to base using the screw provided.
2.
Slide banners over crossbars.
3.
Connect end uprights and lower crossbars to the stand-off
4.
Connect internal uprights and lower crossbars to the stand-off.
5.
Connect end upper crossbar to upright using the knob screw provided.
6.
Connect internal upper crossbar to upright using the knob screw provided.
NOTE: Model shown below may differ in height and width from your model, but assembly instructions remain the same.
1.
4.
2.
3.
5.
6.
Applicable Products:
PVC3
PVC3C
PVC4
PVC4C
PVC3 Shown
Advertisement
Table of Contents
Related Manuals for Testrite Visual Privacy Stand PVC3
Summary of Contents for Testrite Visual Privacy Stand PVC3
- Page 1 Privacy Stand™ Applicable Products: PVC3 PVC3C Attach stand-off to base using the screw provided. PVC4 Slide banners over crossbars. PVC4C Connect end uprights and lower crossbars to the stand-off Connect internal uprights and lower crossbars to the stand-off. Connect end upper crossbar to upright using the knob screw provided. Connect internal upper crossbar to upright using the knob screw provided.
- Page 2 Privacy Stand™ Applicable Products: PVC5 PVC5C Attach the lower upright to the base, using the screw provided PVC6 Connect the upper upright to the lower upright. PVC6C Connect the snap-on clip to the uprights. Attach the graphic. PVC5 Shown...
Need help?
Do you have a question about the Privacy Stand PVC3 and is the answer not in the manual?
Questions and answers