Advertisement
Table of Contents
Charisma SEG 3D Lit™ - XS Series
Frame Assembly
Triangular towers have fewer parts than rectangular or cube units, but assembly steps are the same.
1. Connect each frame side to the plastic corner, then fasten using the screws provided. If corners are labeled, connect like numbers,
1 to 1, 2 to 2, etc.
2. Repeat step 1 for each frame side.
3. If using single Light module: The light is designed to be hung vertically (hanging horizontally can decrease the unit's lifespan)
from the wires at the top and wires on the bottom. Each end of the light module has a hook with a spring loaded latch. Depress
the spring loaded latch at the top of the light module and hang the top wires to the top hook.
4. For connecting additional Light modules on larger models: A wire is included to hang one light from the next. Depress the
spring loaded latch of the bottom hook on the 1st light, and connect the provided wire to the bottom hook of the 1st light.
Depress the spring loaded latch on the top hook of the 2nd light, and connect the free end of the wire to the top hook of the 2nd
light. Connect the short power cord to the bottom covered male plug of the 1st light and top female plug of the 2nd light.
1.
Triangular
Cube/Rectangular
2.
3.
Top hanging wires for light
Light module
Top hanging
wires for light
Latch hook
Cube
XS3C-LED shown
Rectangular Tower
Triangular Tower
XS3T-LED shown
XS3G-LED shown
4A.
Joining
hanging
wire
4B.
Covered
male
plug
Short
Joining
power
cord
Female
plug
Version: 1
Page 1 of 2
Advertisement
Table of Contents
Related Manuals for Testrite Visual Charisma SEG 3D Lit XS Series
Summary of Contents for Testrite Visual Charisma SEG 3D Lit XS Series
- Page 1 Charisma SEG 3D Lit™ - XS Series Frame Assembly Triangular towers have fewer parts than rectangular or cube units, but assembly steps are the same. 1. Connect each frame side to the plastic corner, then fasten using the screws provided. If corners are labeled, connect like numbers, 1 to 1, 2 to 2, etc.
- Page 2 Charisma SEG 3D Lit™ - XS Series Frame Assembly (continued) 5. Connect the bottom of the last light module (or single light module) to the bottom hanging points. All light modules should have a vertical orientation. 6. Plug the female end of the included long AC power cord into covered male end of the last light module. Identify where the power cable will exit the 3D box, and place cord through that point before installing graphics.
Need help?
Do you have a question about the Charisma SEG 3D Lit XS Series and is the answer not in the manual?
Questions and answers