Advertisement
SOLENOID VALVE
SVA20 Series
Solenoid Valve
② There is a concave niche on the back of the solenoid valve as figure 1 shows. Insert a flathead
screwdriver into it and to pull up a solenoid valve as figure 2 shows.
Figure 1
③ To mount a solenoid valve on a manifold base, insert the valve toward the arrowed direction with
attentions to the connection of a base connector and a fixing pin.
Fixing screw
④ Tighten a fixing screw with the tightening torque 0.35-0.4Nm.
7. Detachable Individual Plug-in Connector
● Detachable Individual Plug-in Connector
■ The individual Plug-in Connector is attached by inserting the connector into the socket.(Figure 3)
■ In order to detach the connector, push the latch to the arrowed direction in the figure below and pull out
the connector.
Series
Flathead Screwdriver
Fixing pin
Valve
Connector
Figure 2
Base connector
Manifold side
* Insert to a socket with the latch facing down.
Connector back side
White: B side coil
Red: COM+V
Solenoid Valve
P
A
R
A
A
A
B
A
B
A
B
A
B
A
B
B
P
B
B
R
P
A
R
A
A
A
B
B
B
B
Latch
Black: A side coil
Advertisement
