What Happens In Each Cycle - Whirlpool LPR4231A Use & Care Manual

For model LPR6244A, one faucet
washer connection:
l
Set Temperature knob to MANUAL
SELECT. (This allows you to adjust
the water temperatures at the faucet.)
l
See pages 8-9 for details on chang-
ing water temperatures at the faucet.
3. Select cycle and wash time
Start the washer
l
Push in the Cycle Control Knob and
turn it clockwise.
l
Stop when the indicator points to the
number in the wash cycle you want.
The numbers are minutes of wash
time.
PUSH STOP
l
Start the washer by pulling out the
Cycle Control Knob. The washer will
fill to the selected water level with the
selected wash water temperature.
The washer will begin agitating
immediately after filling. Agitation can
occur with the washer lid up or down.
l
To stop the washer at any time, push
in the Cycle Control Knob. To restart
the washer, pull out the Cycle Control
Knob.
VVE;J happens in each
Each cycle has been designed for
different kinds of fabrics.
When the Cycle Control Knob is
set to a number and pulled out, the
washer fills before agitation and timing
starts. After agitation starts, the knob
turns clockwise until it points to OFF
and the cycle ends.
The washer will pause briefly
throughout each cycle. These pauses
are normal for washer operation.
Gentle Wash System
For better fabric care in the REGULAR/
HEAVY and PERMANENT PRESS
cycles, the agitation speed is reduced
during the last few minutes of wash
agitation time.
7