Table of Contents
Advertisement
Operating
Your Washer
In This Section
Par33
Before
starting
your wamher
-5
............................................................
Selecting
a cycle and time
6
Starting
or stopping
your washer
.................... .5
Using rinse and spin ........................................
6
Selecting
a load oizo ..........................................
5
Using drain and spin ... . ..................................
.6
Selectfng
wash-rinse
temperatures
................. .6
What happens
in each cycle ..........................
.6
Operating your washer properly ensures maximum washing efficiency. This section gives you
important information to help you to select a cycle, time, and temperature for your wash load.
Before
starting
your washer
Add measured detergent. Then place a sorted
NOTE: If your washer has a Consumer
load in the washer before starting. See page 12
Feature Guide, remove it and place it in your
for additional "Before you wash" information.
Use and Care Guide.
Starting
or stopping
your washer
Starting your washer:
1. Select a load size and water temperature.
2. Push in the Cycle Control Knob and turn it
clockwise. Stop when the indicator on the
knob's outer ring points to the number (or
mark) in the wash cycle you want. The
numbers are minutes of wash time. Make
other selections, if necessary.
3. Pull out the Cycle Control Knob.
Refer to pages 6-9 for additional information to
help you make selections.
Stopplng and rastartlng
your washer:
l
To stop the washer at any time, push in the
Cycle Control Knob.
Cycles
may vary with model
l
To restart the washer, close the lid (if neces-
sary) and pull out the Cycle Control Knob.
Selecting
a load size
Position the Load Size Selector at the setting
that corresponds to the size load you want to
wash. Select a load size based upon the size
of the load and the fabric you are washing. See
page 12 for additional loading information.
Advertisement
Table of Contents
