Velleman MICROBIT User Manual page 15

Let's get started!
Step 1
 Insert the micro:bit into the BoB.
 Connect the crash sensor to pin 0 (P0), the green LED to pin 4 (P4) and the red LED to pin 1 (P1) using
the jumper wires Make sure for all components that the colour of the wires matches the colour of the
pins on the breakout board.
 Plug the OLED into the I²C row at the bottom of the BoB as shown in the image.
Step 2 – Pre-Coding
Refer to Project 1, Step 3 – Pre-Coding.
V. 01 – 17/01/2019
VMM502
15 ©Velleman nv