Velleman MICROBIT User Manual page 10

Step 2
 Connect the buzzer to P0 on the BoB.
 Connect the ADKeypad to P2 on the BoB.
 Make sure for all components that the colour of the wires matches the colour of the pins on the
breakout board.
G = ground = black wire, V (3V3) = power = red wire, S = data or signal pin = yellow wire.
Step 3 – Pre-Coding
 Go to http://www.makecode.com. Click onto the micro:bit button to enter the code editor.
 We will need to add a package of code to be able to use our kit components. Click on
Code Drawer to see more code sections and look at the bottom of the Code Drawer for
Extensions.
 The following pop-up window appears.
 Now we search for Tinkercademy. Type
 Click on the Tinkercademy
 Click on the Tinkercademy
V. 01 – 17/01/2019
VMM502
Tinkercademy
(button) package for downloading and adding it into the Code Drawer.
button.
10
in the search box and hit enter.
Advanced in the
Add Package =
©Velleman nv