Configuring The Volume - Bosch DSDA ISCSI DISK ARRAY SERIES DSA-N2B20 Installation Manual

12 en | Configuration through the Web Interface
19. The changes are summarized on the Commit screen.
NOTICE!
i
If you are using the VRM Video Recording Manager application (Version 1.5 or higher), all
further settings are made through VRM.
If you use the digital storage systems for direct recording, continue with the following steps.
5.3

Configuring the Volume

The system is preconfigured with one volume that contains either two or three hard disks. You
need to add the remaining disks of your system to the volume in order to use their capacity.
20. In the navigation panel, select Volumes > Manage.
21. Click vol0 to display and change the properties of the volume.
22. Click Add Disks. This starts a wizard for adding disks to the existing volume.
23. Click Next on the welcome screen of the Volume Wizard.
24. Disk Selection: Check Automatic. Click Next.
25. Disk Size: Select Any Size. Click Next.
26. Number of Disks:
V 1 | 2008.08
Click Commit to apply the new settings.
The preconfigured volume, named vol0, is listed.
– DSA-S5B50: Select the maximum number of disks available from the list. Click Next.
– DSA-N2B20 / DSA-N2B50, no extension shelves: Select the maximum number of
disks available from the list. Click Next.
– DSA-N2B20 with extension shelves: Add 9 disks. Later on, create further volumes as
described in Section 6.1.4 Adding New Volumes, page 19.
Click Next.
– DSA-N2B50 with extension shelves: Add 17 disks. Later on, create further volumes as
described in Section 6.1.4 Adding New Volumes, page 19.
Click Next.
Installation Guide
DSDA iSCSI Disk Array Series
Bosch Security Systems