Keypad Programming - East Coast Gate Operators ECGO-GKP Setup Manual

Keypad Programming

The homeowner can send a text to the unit to configure pin codes that can be entered at the key pad. For
example, if the homeowner would like to enter a pin code at the keypad to hold the gate open while mowing the
lawn and re-enter the same pin code to close the gate, you can do that by following the instructions (See Function
2) shown below.
Function
Function
Code
Momentary
trigger gate
open on Relay
1
1
Note: Primary
gate should be
configured to
use Relay 1
Latch or Hold
2 Open on Relay
1
Momentary
trigger gate
3
open on Relay
2
Latch or Hold
4
on Relay 2
Delete one
NA
code
Delete all
NA
codes
Retrieve all pin
NA
codes
Code
*12*1234#87(Function number) pin code)#
*12*1234#87154321#
1=Function
54321= pin code
*12*1234#87212345#
2=Function
12345= pin code
*12*1234#87365432#
3=Function
65432= pin code
*12*1234#87423456#
4=Function
23456= pin code
*12*1234#88112345#
1=Relay
12345= pin code
*12*1234#88*#
*24*1234#
Note
Once "OK" response is
received from the unit,
the homeowner can
enter 54321 at the
keypad to trigger the
gate to open
Once "OK" response is
received from the unit,
the homeowner can
enter 12345 at the
keypad to cause the
gate to open and stay
open. When the
homeowner is ready to
close the gate, they
simply need to enter
12345 on the keypad
again to cause the
gate to close and
function normally.
This message would
delete the ability to
enter 12345 at the
keypad that was
previously entered to
trigger the gate to
open
15 | P a g e