Setting Up The Ldt-R1; Sony Venice; Setting Up The Camera; Overlay Lens Data On A Monitor - DCS LDT-R1 User Manual

Setting up the LDT-R1
Push the joystick in to enter the menu, use the back button to go back:
● Power the LDT-R1 with the PWRA or PWRC cable to a 2-pin or Dtap power
source,
● Choose Menu > Settings > Data source > Local,
● Choose Menu > Settings> Recording Mode > DXL, Element Tech.
Sony Venice
Setting up the Camera
Sony Venice does not require any setting up to accept the Cooke /i information
coming from the 4-pin LEMO installed on the lens mount.
Overlay Lens Data on a monitor
In order to display lens data as overlay on a SDI monitor, do the following:
● Choose Menu > Monitoring,
● Select the desired SDI output,
● Press down the control knob and select Setup,
● Navigate to Lens Status and check Info,
● Choose the desired unit of measurement, the default is feet.
Rigging the LDT-R1
● Connect the MDR to the LDT-R1 MDR port with the MDR (blue) cable,
● Use the Cooke/i (yellow) cable to connect the Sony Venice's lens mount to the
LDT-R1 CAM port,
● Power the LDT-R1 using the PWRA or PWRC cable to a 2-pin or Dtap power
source.
Setting up the LTD-R1
Push the joystick in to enter the menu, use the back button to go back
● Choose Menu > Settings > Data source > Local
● Choose Menu > Settings> Recording Mode > Cooke /i
Internal Recording
Refer to this section if you are recording data in the LDT-R1. This mode is available
for all types of cameras. LDT-R1 requires shutter pulse or record tally from the
LDT- R1 User Manual
16