Advertisement
l
If your machine has a slide Load Size Selec-
tor, you may set the load size anywhere on or
between the ex small and ex large settings.
To change the load size setting after the washer
has started to fill, move the Selector to the
desired new setting.
NOTE: If your washer has RESET on the Load
Size Selector, change the load size selection by
first moving the Selector to RESET, then to the
new load size.
Slide selector
with "Reset"
Load size tips
l
Items should move freely in the washer. Do
not overload the machine or select a load size
that is too small for the wash load.
. Use a large load size setting for best results
with permanent press clothes.
l
Reduce wash time when using a small load
size setting. Loads with only a few small items
need less wash time.
Selecting
wash-rinse
temperatures
Your washer has a knob, CLEAN TOUCH'" or
push button Water Temperature Selector. Match
the water temperature to the type of fabric and
soils being washed. The top temperature is the
wash water and the bottom temperature is the
rinse water.
Water
temperature
tips
l
Use warm wash water with the Permanent
Press and Delicate cycles.
l
Always use cold rinse water for permanent
press fabrics.
l
For heavily soiled permanent press or knit
clothes, pre-wash or pre-soak before washing
in warm water.
See the "Water usage guide" on page 16 for
mnre information.
Knob selector
Push button selector
Selecting
a cycle
and time
You will find information you need to help you
make correct cycle selections in this section
. Pages 7-8: Use the information on these
pages to guide you when selecting a wash
cycle and time.
l
Page 9: Use this page to help you understand
what happens during a wash cycle.
CLEAN TOUCH selector-
an indicator
appears
above the water
temperatures
selected
6
Cycles may vary with model
Advertisement
