Page 1
Part #13901 SPOT WELDING KIT INSTRUCTIONS...
Page 2
2. Install the supplied Spot Weld Nozzle. Once the Nozzle is installed the welder can be plugged around when welding rather than doing the spot welds all consecutively as it could overheat the back in. NOTE: This Nozzle is designed to fi t the Eastwood MIG Welders but will also work on panel and causing warping.
Page 3
TROUBLESHOOTING • The weld did not penetrate to the rear panel. ° If using the MIG135 make sure a hole is drilled or punched in the top panel. ° Turn up the Volt setting. If this causes the wire to burn back before hitting the panel, increase the wire speed also.