Download Print this page

Pro-Elec PEL01918 Instructions page 2

9” desk fan

Advertisement

ASSEMBLY
Unscrew the rear guard retaining nut (1) from the motor shaft (2).
Fit the rear guard (3) to the body of the fan with the handle uppermost.
Lock into position by firmly tightening the rear guard retaining nut.
Push the fan blades (4) onto the motor shaft aligning the pin in the slot.
If not already attached, fit the decorative
cap (5) to the front guard using the screws
supplied.
Hook the front fan guard (6) onto the rear
fan guard and close the clips on the side of
the front guard to fix it into position.
Use the nut and bolt (7) provided, at the
lower point lock the two guards together.
OPERATION
Connect the mains plug to a suitable outlet.
Oscillation: In order to make the fan oscillate, push down the oscillation knob (8).
To stop the fan head from oscillating, pull up the oscillation knob.
Select the desired speed using the speed control (9):
0 = device off
1 = Low speed
2 = High speed
Caution: Press only one speed control button at a time. Permanent damage to the
switch housing may result if two or more buttons are pressed simultaneously.
CLEANING & MAINTENANCE
Before cleaning, switch the fan off and unplug from the power supply.
To clean the fan, use a soft cloth to wipe off any dust. If the fan is very dirty, use a
damp cloth and wipe dry.
Do not use any chemicals, abrasives or solvents that could damage the fan.
Store the fan in its original packaging in a dry, well ventilated area.
The motor bearings are permanently sealed and do not require additional
lubrication.
TECHNICAL SPECIFICATION
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical
& Electronic Equipment (WEEE). Any WEEE marked products must not be mixed with
general household waste, but kept separate for the treatment, recovery and recycling of the
materials used. Contact your local authority for details of recycling schemes in your area.
Power consumption
Main voltage
Dimensions (HxWxD)
Weight
6
5
22W
220-240V~ 50Hz
370 x 270 x 210mm
1.2kg
1
4
3
2
9
7
Made in China. PR2 9PP
Man Rev 1.1
8

Advertisement

loading

This manual is also suitable for:

Pel01919Pel01918-euPel01919-eu328743532874363287465 ... Show all