Sony CCMA-2DAR Connection Manual page 2

Microscope Connection Guide for the CCMA-2DAR Adapter
Adjusting
the Viewing
Angle Position
While looking through the
1
microscope's ocular lens, centrally
place the chart printout (your chart
for adjusting the viewing angle
position). The recommended
working distance is 20~30 cm.
Now use the hexagonal wrench to
4
adjust the up, down, left, and right
positions so that your chart
appears in the center of the
monitor.
For the controller cable, slide the joint and pull it
1
directly out.
MK20402V1OHB20JAN
and the MCC-1000MD
Connecting to the Leica M525
3
Operating Procedure
20~30 cm
Focus wrong
Focus correct
While viewing the chart displayed on the
5
monitor, adjust the focus by holding down
the NEAR and FAR buttons on the controller.
Advice on Cable Disconnection
For the camera cable, pull it out while turning the
2
ring of the joint.
Turn on power to the MCC-1000MD,
2
M525 and monitor to display your
chart on the monitor.
If iris adjustment is required, turn
6
the dial to adjust the iris setting.
For the camera head, turn the main unit to
3
remove/attach it (make sure to disconnect the
camera cable).
Support call:
Email:
While viewing the monitor, adjust
3
the rotation by using a hexagonal
wrench to loosen the screw
securing the camera adapter and
camera head, then tighten the
screw with this wrench to secure
the screw again.
TIPS
If the remote control does not work due
to the deterioration of battery
performance, you can use the adapter's
FOCUS dial to adjust the focus (For
emergency purposes only; be careful
not to touch the clean field.)