ASSEMBLY
4
Attach the Grill Door Handle
of the Grill Door Handle. Place the Washers on the Bolts, and from the inside of the door, insert
one through each eyelet in the grill door into either end of the Grill Door Handle. Fully tighten both
Bolts using the included Wrench.
Hardware Used (pre-installed in handle):
Bolt (1/4x20) x 2
Washer (1/4) x 2
5
Attach the Haul Handle
w
: Loosen and remove the two Flange Nuts and Spring Washers from
either end of the Haul Handle. Insert the threads on the Haul Handle into the eyelets below the
Chimney. From inside the Grill Body, slide a Spring Washer onto each set of threads, then secure each
end with a Flange Nut. Fully tighten both Flange Nuts using the Wrench.
Hardware Used (pre-installed on Haul Handle):
Flange Nut (10-32) x 2
Spring Washer (10-32) x 2
Contact us for assistance: (866) 985-7877 | www.primepelletgrills.com
e
: Loosen and remove the two Bolts and Washers from either end
4
5
e
w
ASSEMBLY | 8