Assembly Pages - Prime KC King 300 Manual

ASSEMBLY
A MAJOR CAUSE OF FIRES IS FAILURE TO MAINTAIN REQUIRED CLEARANCES (AIR
SPACES) TO COMBUSTIBLE MATERIALS. IT IS OF UTMOST IMPORTANCE THAT THIS
PRODUCT BE INSTALLED ONLY IN ACCORDANCE WITH THESE INSTRUCTIONS.
PREPARATION
Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. READ ALL INSTRUCTIONS BEFORE INSTALLING AND USING THE APPLIANCE.
Place all parts on a nonabrasive, level surface for assembly.
Estimated Assembly Time: 60 Minutes | DO NOT over tighten hardware!
1
On a protected, level surface on the ground, turn the Grill Body
Attach the Support Legs 3 inside the corners of the skirt of the Grill Body, as
shown: Align the bolt eyelets in each leg with the eyelets in corners of the skirt
panels of the Grill Body. Insert Bolt C into the front skirt panel of the grill and through
the leg, fastening with Washer H, Spring Washer I, and Flange Nut E. Repeat with
the same hardware on the back leg. Insert 2 Bolts D into the two eyelets in the side
skirt panel on either side of the hopper, and through the Support Legs. Secure with
the same combination of fastening hardware H/I/E.
4
Attach the Wheeled Legs to the opposite end of the Grill Body, as shown: First
make sure that the wheels are positioned on the sides of the legs AWAY FROM
the grill. Insert Bolt C into the front skirt panel of the grill and through the leg,
fastening with Washer H, Spring Washer I, and Flange Nut E. Repeat with the
same hardware on the back leg. Insert 2 Bolts D into the two eyelets in the bottom
edge of the side skirt panel, and through the Wheeled Legs. Secure with the same
combination of fastening hardware H/I/E.
Hardware Used:
C Bolt (5/16x55) x 4
E Flange Nut (5/16) x 8
I Spring Washer (5/16) x 8
Contact us for assistance: (866) 985-7877 | www.primepelletgrills.com
1
D Bolt (5/16x75) x 4
H Washer (5/16) x 8
upside-down.
H I E
D
1
C
3
C
1
4
4
C
3
C
ASSEMBLY | 6