Prime KC King 300 Manual page 7

ASSEMBLY
2
Carefully turn the grill back upright. Install the Hopper/Fire Pot
Pot into the large opening on the side of the Grill Body
wire extending from the facing sides. Pull these up and out of the way until the Hopper
is fully installed. Fasten the Hopper to the Grill Body using Bolt B/Spring Washer J/
Washer G as shown in the illustration: place a Spring Washer, then a Washer on
each Bolt. From inside the Grill Body, insert each Bolt through 1 of the 4 eyelets drilled
through the side of the Grill Body and into the Hopper. Once all 4 sets of hardware are
placed, fully tighten all Bolts using the included Wrench.
After installing Hopper/Fire Pot, connect the two wires together as shown in the circled
portion of the diagram at right, then tuck the wires into the space between the Hopper
and the Grill Body.
Hardware Used:
B Bolt (1/4x20mm) x 4
G Washer (1/4) x 4
J Spring Washer (1/4) x 4
3
Install the Chimney 9 : Open the grill door. Align the Chimney Gasket
with the open end of the Chimney, then align both with the eyelets on
either side of the exhaust hole on the body of the grill. Insert 2 Bolts A into the
eyelets and fasten them on the inside of the grill using a Washer G and Flange
Nut F on each Bolt.
Fully tighten Chimney hardware.
Hardware Used:
A Bolt (1/4x20) x 2
F Flange Nut (1/4) x 2
G Washer (1/4) x 2
Contact us for assistance: (866) 985-7877 | www.primepelletgrills.com
2 by sliding the Fire
1 . (NOTE: both parts have a
2
q
3
2
2
GJB
GJB
F G
9
A
q
ASSEMBLY | 7