Related Manuals for Panduit OPTICAM 2
Summary of Contents for Panduit OPTICAM 2
- Page 1 FS132C © Panduit Corp. 2017 OPTICAM 2 QUICK SETUP GUIDE Please register and update the OptiCam 2 Tool to the most recent firmware available at Panduit.com > Support > Download Center > Software/Firmware/Printers > OptiCam 2 Termination Tool.
-
Page 2: Technical Information
IEC 60825-1 Class 1 Laser product Failure to observe this warning can result in bodily injury. Connectors: LC, SC, ST, singlemode and multimode, Panduit connectors only Warning: Risk of fire. Battery can explode or leak and cause injury if installed Power Supply: 2 size AA (type L91) 1.5volt Lithium Iron Disulfide... -
Page 3: Product Overview
FS132C © Panduit Corp. 2017 LCD display guides user through the termination process Self-aligning, reversible cradle for left or right Launch cord orientation (right Product Overview removeable for orientation shown) changing from single or multimode fiber 5-way joystick navigates users... - Page 4 FS132C © Panduit Corp. 2017 Step 3 Install the correct OptiCam 2 launch cord LC Connector port and OptiCam 2 cradle. An LC connector on the launch cord attaches to a port at the top of the tool and the unique Data Port adapter attaches it to the cradle.
- Page 5 FS132C © Panduit Corp. 2017 Step 6 To start the connector test, select the “Next” icon, pressing the navigation button directly down. The tool will perform a background test of the connector. After passing the background test, the “Insert Fiber”...
- Page 6 FS132C © Panduit Corp. 2017 Step 7 Validate IL value meets project requirements. Re-test icon If needed, re-test by using the “Re-test” icon, or re-terminate using the “Back” Back icon icon and reperform steps 5 and 6. The OptiCam connector can be reused up to three times.
-
Page 7: App Overview
Tool Settings>Wireless>On. Then select “Exit”. Note: The tool name is found under Enter the wireless password given when registering the tool at Panduit.com Menus>Tool Settings>Tool Name. Rename for ease of use. Then turn wireless on. Step 2 Enter Project Create a new project in Connect-It app. - Page 8 FS132C © Panduit Corp. 2017 Step 3 Connect to the OptiCam 2 tool, pull down to refresh the list, and select the appropriate tool name from the list. Step 4 The app will indicate that the tool has un-synced records if terminations were done on the tool without the app and tool being synced.