Table of Contents
Advertisement
78K0R/Lx3 – Sense it!
10. IAR Embedded Workbench debug session
The pre-programmed sample application is also provided as an IAR Embedded Workbench project on the
starter kit CDROM.
10.1 Setting up the Hardware for a debug session
To be able to perform a C-SPY debug session on the 78K0R/Lx3 Sense it! demonstration kit board please
make sure that the hardware is set up correctly. Therefore please refer to
chapter 2.1
and set the hardware
to the Debugging/Writing Mode.
10.2 Load the IAR Embedded Workbench sample project
After copying the IAR sample project to the hard drive of your Host PC as described in
chapter 6.2
you shall
be able to run this sample project.
To start the IAR Embedded Workbench 16K Kickstart for 78K click Start
All Programs
IAR Systems
IAR Embedded Workbench for 78K v4.62 Kickstart
IAR Embedded Workbench.
The Embedded Workbench Startup screen comes up. To open the sample project workspace press the
Open existing workspace button and locate the 78K0RLx3-SENSEIT_sample.eww file in the sample
program folder.
Figure 26: IAR Embedded Workbench Startup screen
The project shall show up on the left side of the IAR Embedded Workbench window in the Workspace view.
_______________________________________________________________________________________________
U20191EE1V0UM00
User's Manual
42
Advertisement
Table of Contents
