Goalsetter Systems Top Hoops Extreme Series Installation And Owner's Instructions

Goalsetter Systems Top Hoops Extreme Series Installation And Owner's Instructions

Adjustable height goal system

Advertisement

Quick Links

w w w . T o p H o o p s . c o m
T o p H o o p s • i n f o @ t o p h o o p s . c o m • 8 8 8 . 8 7 8 . 2 9 4 2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Top Hoops Extreme Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Goalsetter Systems Top Hoops Extreme Series

  • Page 1 w w w . T o p H o o p s . c o m T o p H o o p s • i n f o @ t o p h o o p s . c o m • 8 8 8 . 8 7 8 . 2 9 4 2...
  • Page 2: Safety Instructions

    6’-4” (1.93 m) to the bottom of the backboard. Goalsetter Systems, Inc. reserves the right to make changes at any • DO NOT CLIMB THE POLE OR HANG on the rim or any part of time without notice or obligation.
  • Page 3: Goal Specifications

    Goal specifications X454 X448 Pole Size: 4”x4” 4”x4” Backboard Size: 36”x54” 32”x48” Weight w/Acrylic: 260 lbs. 255 lbs. Weight w/Glass: 300 lbs. 285 lbs. (A) Height Range: 6’8”-10’ 6’8”-10’ (B) Extension Distance: at 10’ 31” 31” at 8’ 36” 36” at 7’...
  • Page 4: Ground Anchor Installation

    Ground anchor Installation Step 1: Locate and unpack ground anchor. Remove TIME OUT TIP: The arrow on the decal plastic plugs from bolt holes and ensure the threads are in good MUST be pointing toward the playing surface. condition. REPLACE THE PLUGS – they will keep concrete and debris from the bolt holes during installation.
  • Page 5 Pole assembly Step 2: Unpack pole and jack. Jack comes packaged with IMPORTANT the pole. Jack will be used in Jack Attachment instructions. • Allow 48 hours for concrete to cure before beginning. • Check to see that no concrete or debris obstructs threads in Step 3: Align pole hinge with anchor plate hinge, then ground anchor bolt holes by threading anchor bolts in and out.
  • Page 6 extension arm attachments Step 3: Attach upper extension arm pivot holes WARNING with upper holes in pole following the same hardware and Two or three people in good physical condition and capable of procedure as in Step 2. lifting at least 90-100 lbs. (40-45 kg) each are recommended for safe installation and assembly.
  • Page 7 Jack attachment Step 3: Extend jack by turning jack handle counter- WARNING clockwise until upper jack bracket is aligned with holes in lower Two or three people in good physical condition and capable of extension arm. lifting at least 90-100 lbs. (40-45 kg) each are recommended for safe installation and assembly.
  • Page 8: Backboard Attachment

    Backboard attachment Step 2: Carefully lift the bottom of the backboard to WARNING align lower backboard holes with lower extension arm Two or three people in good physical condition and capable of holes. Using ratchet and wrench, attach backboard to arm using lifting at least 90-100 lbs.
  • Page 9: Goal Alignment

    Goal alignment Step 4: Fasten pole to threaded ground anchor plate WARNING! by installing and hand tightening the three rear anchor bolts with For safe assembly, do the following: lock washers. • Use two or three people to raise goal assembly and hold it in a vertical position.
  • Page 10: Rim Attachment

    rim attachment Step 2: If not already removed, remove cover plate NOTE: Use all steps of the following instructions to install a reflex rim. To install a static rim, follow all steps except Steps 2 and 6. screws and cover plate from rim assembly. Step 3: Starting with the top two mounting holes, TIME OUT TIP: Your warranty card is located...
  • Page 11: Height Indicator Attachment

    Height Indicator attachment Step 1: Position top of rim 7’ above playing surface by turning crank handle. Step 2: Measure distance with a tape measure for accuracy. Step 3: Draw a mark on inner tube at edge of outer jack tube. Step 4: Extend jack approximately ½”.
  • Page 12 IMMEDIATELY. • Contact Goalsetter Systems, Inc. for replacement parts. Only use parts provided by Goalsetter Systems, Inc. Use of other parts (a) may cause the goal system to fail, (b) could result in death, serious injury or property damage, and (c) will void the warranty.
  • Page 13 Goalsetter Systems, Inc. shall have the right to require the purchaser to deliver at its expense the allegedly defective product to Goalsetter for Other Portable Systems: GS1000 – 2 year limited warranty; GS4500: testing, repair or replacement.
  • Page 14 Systems, Inc. does not assume, and no other person or representative is authorized to assume for Goalsetter Systems, Inc. any other liability in connection with the sale of Goalsetter System products. Questions or Comments? Phone 800.362.4625...
  • Page 16 Phone 800.362.4625 Fax: 641.594.3343 Email:info@goalsettersystems.com www.goalsettersystems.com 1/2011...

This manual is also suitable for:

X454X448

Table of Contents