Do you have a question about the Dust RIGHT and is the answer not in the manual?
Questions and answers
Paul Clark
February 7, 2025
I have the 1250 CFM Dust Tight Vac ..at what level does the bag need to be changed to maintain efficiency..at the moment my small micron bag is about 20% filled
1 comments:
Mr. Anderson
February 10, 2025
Empty the Drum Plastic Bag once contents reach the full line on the window. Ensure the inner frame is reinstalled after emptying.
Page 1
1250 CFM Wall-Mount Dust Collector Instructions Effective May 2019 Review full manual instructions prior to use for important safety information. Always check Rockler.com to confirm that you are using the most recent manual version for your product.
Instructions and safety warnings for your product (see the • Keep children and bystanders away from the tool Instructions link on the product page at Rockler.com). operating area; • Do NOT use power tools in explosive environments, or in >...
PRODUCT SPECIFIC SAFETY WARNINGS IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING (THIS APPLIANCE) Failure to understand and follow all safety warnings and instructions could result in fire, electrical shock or serious injury. Safe Use Electrical/Grounding >...
Page 4
Installation/Assembly turning it on. > Do NOT install the Dust Right 1250 CFM Wall Mount Dust Collector outside the work area, especially if the work area Maintenance > To avoid injury from accidental starting, turn the unit off contains a gas-fueled appliance.
Yellow Safety Key PARTS LIST Quantity Motor Assembly Foam Tape Bag Clamp Y Fitting Vibration Dampeners 5/16" x 3" L Washer Head Lag Screws #10-24 x 3/8" Washer Head Screw Remote Control* (not shown) * Remote Control (9) requires a 9-Volt battery (not included)
Choosing a Mounting Location > Do NOT install the Dust Right 1250 CFM Wall Mount > Do NOT use wall anchors or drywall anchors to mount Dust Collector outside the work area, especially if the the Dust Right 1250 CFM Wall Mount Dust Collector.
Page 7
Mounting to Open Studs Spaced 16" On Center The Dust Right 1250 CFM Wall Mount The motor assembly of the Dust Right Dust Collector must be secured using all four included 1250 CFM Wall Mount Dust Collector is very heavy. To 5/16"...
Page 8
Fig. 5. 12" The motor assembly of the Dust Right 1250 CFM Wall Mount Dust Collector is very heavy. To avoid the risk of serious injury, you MUST obtain the help of another adult to lift the unit into position.
Page 9
Electrical Connections and Grounding > Do NOT use outdoors or on wet surfaces. > Do NOT use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center.
Page 10
Main Power Yellow Safety Key Circuit Breaker Reset On/Off Switch Remote Reset Dust Collector Power Panel Operating the Dust Collector > Do NOT use to pick up flammable or combustible > NEVER operate without hose connected to suction liquids, such as gasoline, or use in areas where they chute (inlet).
Turning on the Dust Right 1250 CFM Wall Mount Dust Collector IDENTIFICATION OF ASSEMBLED PRODUCT 1250 CFM WALL-MOUNT DUST COLLECTOR INSTRUCTIONS is a two-step process that can be accomplished at the machine or with the Remote Control. (54352/UB105Z) WITH REMOTE CONTROL (IC-315Z)
Page 12
54352 - RL Distributed by Rockler Companies, Inc. Rev 05/19 Medina, MN 55340...
Need help?
Do you have a question about the Dust RIGHT and is the answer not in the manual?
Questions and answers
I have the 1250 CFM Dust Tight Vac ..at what level does the bag need to be changed to maintain efficiency..at the moment my small micron bag is about 20% filled
Empty the Drum Plastic Bag once contents reach the full line on the window. Ensure the inner frame is reinstalled after emptying.
This answer is automatically generated