Advertisement
Lantronix Xport Guide IC2001/4001 Controllers
The Network Mode drop down needs to be set to Wired
Make sure that the "Use the following IP configuration" radio button is selected and the available fields corre-
spond with what you entered earlier when setting up the IP address of the Xport. [Ignoring the DNS server
settings]
Ethernet configuration should be set to "Auto Negotiation"
Speed should be set to the speed of the network
Duplex should be set to full.
If for whatever reason you needed to change any settings on this page, once done click the OK button.
2.
Server - Click onto the network menu the following page will load
All of these settings can be left as default.
If you wish a password to be entered when configuring the Xport do so in the Server Configuration – Telnet/
Web manger password fields [I would advise against this, if the password gets lost or another engineer visits
the site and needs to configure the device, without this password they will be locked out]
sales@sensoraccess.co.uk
www.sensoraccess.co.uk
+44 (0) 1273 242 355
Advertisement
Need help?
Do you have a question about the IC2001 and is the answer not in the manual?
Questions and answers