Qwic Performance Series Manual page 79

The Performance MN380 has been equipped with a
TranzX steer stem, which can be adjusted in height and
angle by loosening just one bolt. This bolt is located at
the front top side of the stem, see picture on the right.
After loosening the bolt, adjust the handlebar and steer
to the desired position. If you are satisfied, tighten the
bolt again with a torque of 10-12Nm.
Do not forget to tighten the bolts after
!
adjustments and make sure that your
handlebars are attached firmly again.
Adjusting the grips
On all QWIC bicycles you can easily adjust the angle
of the grips. In this way you'll always have the most
comfortable grip with a well-divided pressure.
By loosening the Allen screws on both sides on the edge
of the grip (beneath the round holes) with an Allen key,
you can adjust the corner of the handle. Do not forget
to tighten them again when ready.
Adjusting the bicycle
79