Qwic Performance Series Manual page 59

Operation
Switching On and Off
Press the ' ' button on the display to start
the system. Press the same button again to put the
system in standby mode. By pressing and holding the
same button for >2 seconds, the system will turn off
completely.
Power levels
The motor assistance can be set to three different
support profiles. Use the '
console to select your preferred mode:
SPORT: Most powerful mode.
TOUR: Balanced power mode.
ECO: Energy saving mode.
OFF: No motor support. Display stays on.
i
Please note a more powerful motor support
mode will result in a lower range.
Battery indicator
The battery continuously monitors the status of the
battery and displays the remaining charge in both a
percentage (%) as a simple battery icon. In case less
than 10% capacity remains in the battery, you might
experience a decreased motor performance. The screen
will show a flashing battery icon to warn for low charge.
' and ' ' buttons on the
Display & Controls: Mid-drive motor models
Even when motor support ceases because of
low battery capacity, there will still be sufficient
charge available to power the lights and display for
another 3 hours.
Lighting
By pressing the ' ' while the system is
turned on, the lights will be switched on. The
battery of your e-bike supplies the required power
for the lights, no additional batteries are required.
Background lighting
Thanks to the integrated light sensor the
brightness of the display is regulated depending
on the ambient light.
Walk-assist function
Press and hold the ' ' button to activate the
walk assist function. This will only work when
the power level OFF has been selected. In this
situation the small arrow next to the speed
indication is displayed. The walk-assist function
is intended to use while walking alongside the
bicycle. Use this function for example to get your
bicycle up a ramp.
59