Toro 30810 Installation Instructions Manual page 6

4. Adjust the length of the threaded link to 19 cm (7-1/2
inches) and tighten the jam nuts
Figure 9
1. Length of threaded link—19 cm (7-1/2 inch)
5. Secure the rod end of the threaded link to the
link-support assembly with a bolt (1/2 x 1-1/2 inch)
and locknut (1/2 inch) as shown in
Figure 10
1. Threaded link
6. Mount the stationary end of the hydraulic cylinder to
the underside of the frame cross-member bracket with
a pivot pin (Figure 11).
Figure 11
1. Hydraulic cylinder
(stationary end)
2. Grease fitting
(Figure 9).
Figure 10.
2. Link-support assembly
3. Pivot pin
7. Thread a grease fitting into the end of the pivot pin
(Figure 11).
Note: Position the grease fitting as shown in
12.
1. Pivot pin
2. Grease fitting
6
Figure 12
3. Angle of grease fitting—45
degrees
Figure