Toro 30810 Installation Instructions Manual page 4

3. Mount the lift-arm assembly to the rear frame
members, with 2 bolts (7/8 x 4-1/2 inch), 2 jam nuts
(7/8 inch), and as many spindle washers as necessary
to evenly shim between the right and left sides of the
lift arm and rear frame members.
Note: Position the components as shown in
Figure 3
1. Bolt (7/8 x 4-1/2 inch)
2. Lift-arm assembly
4. Torque the bolts and locknuts 518 to 648 N-m (382
to 478 ft-lb).
5. Adjust the length of the threaded link to 19 cm (7-1/2
inches) and tighten the jam nuts
Figure 4
1. Length of threaded link—19 cm (7-1/2 inches)
Figure
3. Spindle washer
4. Jam nut
(Figure 4).
6. Secure the threaded link rod end to the cylinder-support
assembly with a bolt (1/2 x 1-1/2 inch) and locknut
(1/2 inch) as shown in
3.
1. Lift adapter
7. Mount the loose end of the hydraulic cylinder to the
cylinder-support assembly with the cylinder-mount
pivot pin, bolt (3/8 x 1 inch), and nut (3/8 inch) as
shown in Figure
1. Grease fitting
2. Pivot pin
8. Thread a grease fitting into the end of the pivot pin as
shown in Figure
4
Figure 5.
Figure 5
2. Cylinder-support
assembly
6.
Figure 6
3. Hydraulic cylinder
(stationery end)
6.