Toro 30810 Installation Instructions Manual page 14

8
Completing Installation
No Parts Required
Procedure
1. Grease all the new grease fittings with Number 2
lithium-based grease.
2. Check the hydraulic fluid level and replenish as
required.
3. Connect the negative (–) battery cable.
4. Start the machine and operate the rear lift. Check for
leaks and replenish hydraulic fluid as necessary.
Note: If installed correctly, the manifold should have
no electrical power when the key is in the O
Operation
Lift/Lower Switch
Move the switch to the L
IFT
and to the L position to lower the attachment
OWER
33).
Float/Power Down Switch
Moving the switch to the F
attachment to follow the contour of the ground. Moving
the switch to the P
OWER
the machine to increase ground engagement force
33). Higher ground engagement force decreases the traction
capacity of the machine.
Figure 32
Model 30810
1. F / -
LOAT POWER DOWN
switch
FF
position to raise the attachment
position allows the
LOAT
D position adds weight from
OWN
(Figure
2. L / switch
IFT LOWER
1. F /
LOAT POWER
switch
Adjusting the Attachment
Angle
To increase or decrease the engagement angle of the
position.
attachment, proceed as follows:
1. Loosen the jam nuts on the threaded link
2. Rotate the hex tube until you achieve the desired angle
(Figure
3. Tighten the jam nut to lock the adjustment
4. With the engine operating at low idle, raise the rear
(Figure
attachment to make sure that it does not contact the
hood.
1. Threaded link
14
Figure 33
Model 30812
- 2. L /
DOWN IFT
34).
Figure 34
switch
LOWER
(Figure 34).
(Figure 34).