Kohler K-10441 Installation Manual page 5

Remote Valve
Inlet Spout Tube
Sink
3. Install the Remote Valve
NOTE: The remote valve must be located within 8" (20.3 cm) of the
spout.
Slide the O-ring over the supply hoses onto the base of the
remote valve.
Insert the remote valve through the hole in the mounting surface.
Assemble the bracket, washer, and nut to the stud from
underneath the mounting surface.
Align the handle and securely tighten the nut.
Connect the inlet spout tube to the spout hose (not shown). Make
sure the O-ring (not shown) on the inlet spout tube is in place.
Kohler Co.
Stud
Supply Hoses
O-Ring
Bracket
Washer Nut
5 1059390-2-A