Neptune R900 Pocket Reference

Reading Modes

Function Explanation
Normal Mode connects through Bluetooth to a
Normal
host device. Selection between Route (filtered)
and RF Test (unfiltered) is made in the host
device software.
To enter this mode from other modes:
1. Press
2. Press and the mode LED turns
Unattended Operations Mode can operate
Unattended
using the battery or when connected to
vehicle power.
To use this mode with battery power:
1. Press
.
.
2. Press
To use this mode when connected to vehicle
power:
3. Press
.
4. Press and release.
5. Press again and hold for five seconds,
and then release. The Mode LED is
6. Connect the USB.
Note: The USB charger must be capable of
supplying 1A of current
USB mass
storage
until the mode LED flashes
.
Accessing the R900 ® BCT
.
The R900 BCT must first be set to Normal Mode to access the R900 BCT Status
screen.
While en route
until the Mode LED is
From the Synchronize screen
Neptune Customer Support
Call Monday through Friday, 7:00 AM to 5:00 PM Central Time:
until the Mode LED is
(800) 647-4832
FAX your question: (334) 283-7497
E-mail a question: support@neptunetg.com
.
.
The SD card appears as an external drive to
the PC. To enter this mode:
1. Connect the USB to the R900 BCT and to
the PC.
Note: The USB must be connected before the
unit can enter the USB mass storage mode.
until the Mode LED flashes
2. Press
.
3. Press . The SD card now shows as an
external drive attached to the PC.
Neptune Key, System, UTILS, AMR Status =
, , ,
TAB twice, UTILS, Belt Clip Status =
, ,
PRC R900 BCT 01.19 Part No. 13326-002
for the R900 ® Belt Clip Transceiver (BCT)
(Versión en español disponible en
For... Press...
Press for two seconds.
ON
Press for two seconds.
OFF

Setting Date / Time

The R900® Belt Clip Transceiver (R900 BCT)
sets time with the handheld when the two are
paired. This time comes from the last
handheld synchronization.
Pocket Reference
www.neptunetg.com