Sony MVE-8000 Operation Manual page 8

f f CTRL (control) connector (RJ-45) f f
Connect to an Ethernet switch
The MVS-8000 Multi Format Switcher Processor and the
MVS-8000 system's center control panel are connected in
the same way to the Ethernet switch to form a network for
exchange of signals between the devices.
This network is used primarily to control the various
devices from the center control panel.
* For information about Ethernet switches that can be used in an MVS
system, contact your Sony service representative.
For detailed information about setting up the Ethernet
switch, refer to the documentation supplied with the
switch.
For more information about Ethernet switch connectors,
see "MVS-8000 System Configuration" (page 9).
g DATA connector (RJ-45) g
g g
Connect to an Ethernet switch.
The MVS-8000 Multi Format Switcher Processor and the
MVS-8000 system's center control panel are connected in
the same way to the Ethernet switch to form a network for
exchange of signals between the devices.
This network is used primarily for exchange of various
types of data (key frame effects, snapshots, etc.).
h REF INPUT (reference video signal input) h h h
connectors (BNC type)
If you wish to synchronize this unit to an external reference
signal, input the reference signal. For an HDTV system,
input an HD tri-level sync signal, black burst signal, or
analog sync signal. For an SDTV system, input a black
burst signal or analog sync signal.
The two connectors have a loop-through configuration.
Signal input to one connector can be output from the other
connector. If you will not be using the loop-through
output, be sure to terminate the unused connector with the
supplied 75Ω terminator.
8
Location and Function of Parts
*
.