Place the connector sub-assembly in the nest of the tool and position it under the wire insertion punch. Position the wire to be inserted before the hole in the slot that the wire insertion punch slides in. FCI Electronics Manual Part No. 415839-001 Issued: Date (01/22/99) Page 3 of 5 Rev.
Page 4
If the wire is to be soldered, advance the wire into the hole just until the wire insulation barely enters the hole. Squeeze the pliers’ handles until the top detail hits the top of the bottom detail. This inserts the wire. FCI Electronics Manual Part No. 415839-001 Issued: Date (01/22/99) Page 4 of 5 Rev.
Page 5
ELECTRONICS Remove the connector sub-assembly from the tool and inspect results. FCI Electronics Manual Part No. 415839-001 Issued: Date (01/22/99) Page 5 of 5 Rev. 12/10/01 ECR V10367 Revision C PDM: Rev:C Released STATUS: Printed: Oct 03, 2003...