Advertisement
Configuration
Device parameters and settings will be factory programmed based on specifications supplied by the customer. These
settings will be the default values the device stores and can only be changed through factory reprogramming.
Heating and Cooling:
(Select all that apply)
RTU Configuration:
Default Set Points:
Maximum Set Points:
Minimum Set Points:
Set Point Override:
Fan Change:
Default Fan Mode:
Setback:
Setback Set Points:
Lock On/Off Delays:
Units:
Humidity:
Common Wire:
External Connections
A terminal block used for all external RTU connections
will be located at the back of the thermostat accessible
for wiring. The connections available on the terminal
block are as follows:
R
(Power/Heating Power)
RC
(Cooling Power)
C
(Common)
G
(Fan)
W1
(Heat Stage 1) / O/B (Compressor/Damper)
W2
(Heat Stage 2)
Y1
(Cool Stage 1) / Y (Heat Pump)
Y2
(Cool Stage 2)
© Lightstat, Inc., 22 W. West Hill Rd., Barkhamsted, CT 06063 Tel:800.292.2444 Fax: 860.738.4123 www.lightstat.com
Heating – 1 Stage
Cooling – 1 Stage
Conventional
Heat Pump – Active Cooling
Heating (°F): ______________
Heating (°F): ______________
Heating (°F): ______________
Enable
For a Duration (Minutes): ______________
Allowed
Not Allowed
On
Auto
Enabled
Disabled
Heating (°F): ______________
Yes, Delay (Seconds): ____________
Fahrenheit
Celsius
Yes
No
Yes (24VAC)
ecoStat Installation Manual TPUB00045 Rev. A 03052018
Heating – 2 Stage
Cooling – 2 stage
Heat Pump – Active Heating
Cooling (°F): ______________
Cooling (°F): ______________
Cooling (°F): ______________
Cooling (°F): ______________
No
No (Battery)
Disable
Alkaline AAA (x2)
Y2 W2 C Y1 W1 G RC R
L AUX C Y OB G RC R
o o o o o o o o
Advertisement
