Operation Instructions; Setting Up Your Bull Floor Stripper; Prior To Operation; Changing Or Installing Tooling - Bartell Global Contec BULL Owner's Manual And Parts Book

BULL FLOOR STRIPPER
OWNER'S MANUAL

SETTING UP YOUR BULL FLOOR STRIPPER

Your BULL Floor Stripper comes fully assembled with handle and motor fully installed.
The handle is in the lowest position to allow for easier transportation. The handle can be
adjusted to suit the operator by loosening the 2 screws at the base of the handle and
retightening to set position. Tooling can now be installed, and your Floor stripper is ready for
use.

PRIOR TO OPERATION

• Make sure that all dust, debris etc., are thoroughly removed from the unit prior to
operation. Special effort should be given to the bottom of the machine where the tooling
is located, as well as the drive wheels and motor.
• Check all bolts and screws for tightness and make sure all bolts and screws are securely
tightened. Loose bolts and screws may cause damage to the unit. Make sure tooling is
properly installed.

CHANGING OR INSTALLING TOOLING

• Lock the centre weights into position 1 (See below "Adjusting the Weights")
• Tip the machine until it rests in a stable position
• Clean and loosen the bolts of the blade mounting
• Replace the blade.
• Make sure that the blade fits exactly into the support. On normal and hard subfloors, the
bevel of the blade should show upwards (B). On soft subfloors the bevel should show
downwards (A).
• Tighten the bolts of the blade mounting again
ATTENTION: Before working on the floor stripper bring the motor to a total stand still
and disconnect from the power supply.
CAUTION: Tooling is sharp, set wrench in position opposite to blade to avoid injury

OPERATION INSTRUCTIONS

Figure 1: Blade orientation
10
OIPB – C15002