Manually Transferring Data To The Mysense App; Recalling Saved Measurement Values; Battery Display/Changing The Battery - cyclotest mySense Manual

Operating the device

Manually transferring data to the mySense app

If the measurements cannot be transferred to the mySense app
immediately after the measurement (e.g. if your smartphone is not within
Bluetooth range or the mySense app is not open), you can transfer the
measurements to the mySense app at a later date. To do so, proceed as
follows:
• Open the mySense app on your smartphone.
• With the device switched off, press and hold the data transfer button
for at least 1 second, but no more than 5 seconds, until the Bluetooth
symbol appears in the display. If you hold down the button for more
than 5 seconds, you will enter memory recall mode.
• The device now connects to the app via Blue-
tooth (Figure 1).
• If the connection is successful, the "APP" indica-
tor appears (Figure 2).
If the device cannot connect to the mySense app, it
switches itself off after 60 seconds. If this occurs,
check whether Bluetooth is enabled on your smart-
phone and that the mySense app is running, then
try again.

Recalling saved measurement values

The thermometer has a measurement value memory with 30 save slots.
The measurement values are saved automatically together with the date
and time of the measurement. The most recently measured value is stored
in save slot 1; the value measured prior to that is stored in save slot 2, and
so on. If more than 30 measurements are taken, the oldest value (no. 30)
is deleted so that the most recent value (no. 1) can be saved.
EN-14
Figure 1
Figure 2
The measurement values and lots of additional in-
formation are saved in the mySense app, where
they can be analysed with ease.
You can also recall the last 30 readings directly
from the mySense basal body temperature ther-
mometer. To do so, proceed as follows:
• With the device switched off, press and hold the
memory recall button for at least 5 seconds
until the icon appears on the display. The de-
vice switches to memory mode (Figure 1).
• The most recently measured value, no. 1, is
now displayed (Figure 2, Figure 3). The display
switches between the measurement value and
the year, month/day and time. For measurement
values that have been transferred to the myS-
ense app, the symbol is displayed.
• By repeatedly pressing the memory recall key
you can call up the previous measurements (no. 2,
no. 3 ...).
• If no measurement values are saved, the follow-
ing appears on the display (Figure 4):

Battery display/changing the battery

The device is equipped with a CR2032 lithium battery.
If the battery icon flashes on the display while
the thermometer is in use, the battery is low (Fig-
ure 1). You can still perform some temperature
measurements at this point, but you should have a
spare battery ready.
Operating the device
Figure 1
Figure 2
Figure 3
,
Figure 4
Figure 1
EN-15