Temperature Measuring - cyclotest mySense Manual

Operating the device
During the registration process, you will be asked to enter an activation
code for the thermometer. You will find this activation code in the pack-
aging of your cyclotest mySense basal body temperature thermometer.
Once you have successfully completed user registration, the Bluetooth
function on your smartphone will be enabled and the app will search for
available devices.
Now switch the thermometer on. To do this, press
and hold the on/off button for at least 1 second.
The device switches on and automatically does into
SET mode, where you can set the date and time
(Figure 1).
The date and time are synchronised automatically
from the mySense app. To do this, the device con-
nects to the app via Bluetooth (Figure 2).
If the connection is successful, the "APP" indicator
appears (Figure 3).
If the device cannot connect to the app, it switches
off after 60 seconds. If this occurs, check whether
Bluetooth is enabled on your smartphone and that
the mySense app is running. Now try to establish a
connection again.
Once the device is connected successfully, you will be prompted to per-
form a test measurement. This test measurement is used to ensure that
the thermometer and app are functioning correctly and is not saved.
To perform the test measurement, please follow the instructions in the
app and refer to the instructions for measuring wake-up temperature
starting on page 12.
EN-10
Figure 1
Figure 2
Figure 3

Temperature measuring

• Remove the transparent protective cover from the thermometer before
taking a measurement.
• Switch on the device by pressing and holding the
on/off button for at least 1 second.
• The word "On" will appear on the display (Figure
1) and you will hear a beep.
• The device now performs an internal self-test; all
display elements are displayed (Figure 2).
Viewing the most-recent measurement value
If measurement values have already been saved,
the most-recently measured value is shown in the
display with an M (memory). The display switch-
es between the measurement value and the year,
date and time of the measurement (Figure 3).
Checking the transfer status
The device now checks whether all previous meas-
urement values have already been transferred to
the mySense app. The device can temporarily store
up to 30 measurements.
The number of measurement values not yet trans-
ferred is shown on the display (Figure 4).
• If more than 25 saved
measurements have not
been transferred to the
mySense App, the mes-
sage "APP/FULL" (Figures
5 and 6) appears on the Figure 5
Operating the device
Figure 1
Figure 2
Figure 3
Figure 4
Figure 6
EN-11