Boot Menu - ECS Durathon 2 User Manual

Boot Menu

This page enables you to set the keyboard NumLock state.
Main Advanced
Boot Configuration
Operation system Select
Launch PXE OpROM
Launch Strorage OpROM
Fast Boot
VGA Support
USB Support
Network Stack Driver Support
Bootup NumLock State
Quiet Boot
Boot mode select
Set Boot Priority
Boot Option #1
Boot Option #2
Boot Option #3
Boot Option #4
Boot Option #5
Boot Option #6
Boot Option #7
UEFI Hard Disk Drive Priorities
UEFI USB Flash Drive Priorities
Operation System Select (Windows 8.x / 10)
This item is used to select the operation system.
Launch PXE OpROM (Disabled)
The item enables or disables launch PXE Option ROM.
Launch Storage OpROM (Enabled)
Use this item to enable or disable the Storage OpROM.
Fast Boot (Enabled)
This item enables or disables boot with initialization of a minimal set of device
required to launch active boot option. Has no effect for BBS boot options.
VGA Support (EFI Driver)
If auto, only install legacy OpROM with legacy OS and Post logo will not be shown
during post. EFI driver still be installed with EFI OS.
USB Support (Full Initial)
If you select Disabled, all USB devices will not be available until after OS boot. If you
select Partial Initial, specific USB port/device will not be available before OS boot.
If you select Full Initial, all USB devices will be available in OS and POST.
Network Stack Driver Support (Disabled)
If disabled, Network stack driver will be skipped.
Bootup NumLock State (On)
This item enables you to select NumLock state.
Quiet Boot (Enabled)
This item enables or disables quiet boot.
B350AM4-M USER MANUAL
Chipset M.I.B. X
Windows 8.x / 10
Disabled
Enabled
Enabled
EFI Driver
Full Initial
Disabled
On
Enabled
UEFI
Hard Disk: Windows Bo...
CD/DVD
USB Hard Disk
USB CD/DVD
USB Flash: UEFI: USB,...
USB Floppy
Network
Security Boot
Windows 7 or other OS:
Boot policy for Legacy OS.
Windows 8.x / 10: Boot
policy for UEFI OS without
Compatibility Support
Module(CSM).
Manual: User customized
CSM parameters & boot
policy.

: Select Screen

/Click: Select Item
Enter/Dbl Click : Select
+/- : Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC/Right Click: Exit
Exit
61