Flush The Pump - Graco Hydra-clean 24V616 Instructions - Parts Manual

Flush the the Pump Pump
Flush Flush the Pump
To reduce the risk of fluid injection injury, static
sparking, or splashing, relieve the pressure and
remove the spray tip before flushing.
NOTE: Use the lowest possible fluid pressure during
NOTE: NOTE:
flushing.
Before First First Use Use
Before Before First Use
The pump was tested in lightweight oil, which is
left in the fluid passages to protect parts. To avoid
contaminating your fluid with oil, flush the equipment
with a compatible solvent before using the equipment.
1. Engage the trigger lock.
2. Place the suction tube into solvent supply.
3. Hold a metal part of the gun/valve firmly to the
side of a grounded metal pail.
4. Disengage the trigger lock. Trigger the gun until
clean solvent comes from the gun.
5. Engage the trigger lock.
6. Place the suction tube in the prepared cleaning
solution.
7. Hold a metal part of the gun/valve firmly to the
side of a grounded metal pail.
8. Disengage the trigger lock. Trigger the gun until
cleaning solution comes from the gun.
334187H
Before Shutdown Shutdown
Before Before Shutdown
1. Place the suction tube into the water supply.
2. Hold a metal part of the gun/valve firmly to the
side of a grounded metal pail.
3. Disengage the trigger lock. Trigger the gun until
clear water with no cleaning solution comes from
the gun.
4. Engage the trigger lock.
Operation
13