Before Using Your Refrigerator; Clean It; Install Properly; Level Refrigerator-Freezer - Whirlpool ETl8AK Use & Care Manual

Before using your
refrigerator
4. Install properly...
L Remove sales labels...
Remove the Consumer Buy Guide Label, tape
and any inside labels before using the refrigera-
tor. To remove any remaining glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing de-
tergent before removing glue as described in
step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
2. Clean it...
1. Allow 1/2 inch (1.25 cm) space on each side and
Clean your refrigerator before using it. See
at the top of the refrigerator for ease of
installation.
cleaning instructions on page 8.
2. If the refrigerator is to be against a wall, you
might want to leave extra space on the hinge
side so the door can be opened wider.
3. The refrigerator back can be flush against the
wall.
3. Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
REFRIGERATOR
J-PRONG
POWER CORD
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain. See Electrical Requirements and
Grounding Instruction Sheet in your Literature
Package.
5. Level refrigerator-freezer...
FRONT ROLLER
I I
2. To raise front, turn screw in direction shown.
3. To lower front, turn screw in direction shown
4. Check with level.
5. Replace base grille (see page 7).
4