Adding A Pla - ZyXEL Communications PLA6456 User Manual

Figure 15 Plug Your PLA into a Power Socket
1
Connect the PLA to your computer.
2
Use a LAN or Ethernet cable (shown below) to connect the LAN or Ethernet port on your adapter to the
3
same kind of port on your computer.
Figure 16 Connect Your PLA to a Computer
Open the Web Configurator on your computer. See
4
Configurator.
You are now ready to extend your HomeGrid network or set up a second network.
5
• See Section 4.4 on page 29
• See Section 4.5 on page 31

4.4 Adding a PLA

This section shows you how to add a new PLA to expand your existing network.
The figure below shows the family computer with Internet access on a HomeGrid network. Expand the
network by adding a new PLA connected to a printer.
Chapter 4 HomeGrid Network Setup Tutorial
PLA
2
to add a new PLA to your network.
to set up a second network with your new adapters.
PLA6456 User's Guide
3
Section 3.2 on page 17
29
for how to launch the Web