Whirlpool ETIGJK Use And Care Manual page 6

Adjusting the shelves.. .
1 First, remove food from shelf.
2. Slide shelf straight out to stop.
3. Lift front.
4. Slide the rest of the way out.
Replaclng Shelf:
I, Fit back of shelf on top of guides with wire stops
on the bottom of guides.
2. Lift front, slide shelf In until it clears guide stops.
Shelf Guide
Removing crispers and crisper cover.. .
Removing the Crispers:
Lift the Front, Then
the
Back.
1 Slide crisper straight out to stop, lift front, then slide
the rest of the way out.
2. Replace In the reverse order.
Removing Cover:
I. L1f3 front and remove the cover support
2. Lift out cover by pulling up and out
Replacing Cover:
1. Fit back of cover into notch supports on walls of
refrrgerator, then lower front into place.
2. Replace cover support with the long tab towards
the front. Note: If support needs adjustment, turn
base right to lower, or left to raise
Pull out to stop.
the Front and Pull Again.
Ice cube trays...
To remove ice:
t Hold tray at both ends.
2 Slrghtly twrst
If cubes are not used, they may shrink. The moving
cold air starts a slow evaporation The longer cubes
are stored, the smaller they get
Optional automatic ice maker.. .
On
.
daise Signal
L
Arm to Stop Ice Maker
Lower Signal
Arm to Start It
If you have the automatic ice maker accessory or
plan to add one later (Part No ECKMF-83). there are
a few things you will want to know:
l
The ON/OFF lever is a wire signal arm.
Down.. .for making ice automatrcally;
Up...toshut off the ice maker.
l
Shake the brn occasionally to keep cubes sepa-
rated, and to obtain increased storage capacity.
l
It is normal for Ice crescents to be attached by a
corner. They will break apart easily.
l
You WIII hear water running when ice maker is
working. You'll hear ice fall into the bin Don't let
these sounds bother you.
l
The ice maker WIII not operate until the freezer is
cold enough to make ice. This can take overnight.
l
Because of new plumbing connections. the first
ice may be discolored or off-flavored. Discard the
first few batches of ice.
l
If ice is not being made fast enough and more ice
is needed, turn the Refrigerator Control toward a
higher number. Wait a day and, If necessary, turn
the Freezer Control toward A.
l
If You remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin.
push it all the way In and lower the arm to the ON
position.
l
If cubes are stored too long, they may develop an
off-flavor...like stale water. Throw them away. They
will be replaced. Cubes in the ice bin can also
become smaller by evaporation,
l
The ice maker water supply should not be sott-
ened water. The chemicals could damage the Ice
maker molds.
6