ADDER AdderView Matrix AVM208MP Installation And Use Manual page 45

'HOTKEYs' and '1' - selects channel 1
'HOTKEYs' and '2' - selects channel 2
'HOTKEYs' and '3' - selects channel 3
'HOTKEYs' and '4' - selects channel 4
'HOTKEYs' and '5' - selects channel 5
'HOTKEYs' and '6' - selects channel 6
'HOTKEYs' and '7' - selects channel 7
'HOTKEYs' and '8' - selects channel 8
'HOTKEYs' and '9' - selects channel 9
'HOTKEYs' and '1 then 0' - selects channel 10
'HOTKEYs' and '1 then 1' - selects channel 11
'HOTKEYs' and '1 then 2' - selects channel 12
'HOTKEYs' and '1 then 3' - selects channel 13
'HOTKEYs' and '1 then 4' - selects channel 14
'HOTKEYs' and '1 then 5' - selects channel 15
'HOTKEYs' and '1 then 6' - selects channel 16
'HOTKEYs' and 'TAB' - selects the next available channel
'HOTKEYs' and 'M' - displays the on-screen menu for selecting computers by name
(this is the recommended way of selecting computers for systems with more than 4
computers)
'HOTKEYs' and 'A' - selects autoscan mode where each channel is displayed for
the selected time (see section 3.6.11). To cancel autoscan mode simply select any
fixed channel either by hotkey or by using the on-screen menu or the front panel
controls.
'HOTKEYs' and '0' – switches off the video signal. This will cause some monitors to
go into standby mode or switch off. The video signal can be re-enabled by selecting
a channel.
'HOTKEYs' and 'L' - Logs out the user if password security has been enabled or
disables the video and selects the non-existent channel '0' if no security is set.
'HOTKEYs' and 'the cursor keys' - Moves the currently displayed on-screen menu
around the screen.
'HOTKEYs' and '0 then {number}' – (where {number} is 0,1,2,3,4,5,6,7,8 or 9).
Selects the channel specified by {number}. This allows ports on cascaded units to
AdderView MATRIX MP Installation and Use
(16 port models only)
(16 port models only)
(16 port models only)
(16 port models only)
(16 port models only)
(16 port models only)
(16 port models only)
(16 port models only)
Page 44