Advertisement
4
First Use of the TPD 2.8" Mx Series
GND
VDC
(+12-+48 V)
2. Supply power to the TPD-280/283/283U-Mx,
wait for several seconds and then you can see
the default program run on it.
3. Try to touch on the icons on the bottom-right
corner of the screen of the TPD-280/283/283U-Mx and you can find that
TPD-280/283/283U-Mx switches to the setting pages.
5
Hardware Installation
Outlet Box, OB120 (optional)
Technical support:
1. Connect wires as the below figure or
prepare an Ethernet cable which will be used
to supply power through PoE if there's a
RJ-45 Ethernet port on it. And set the rotary
switch to 0 (At this point, the power is not yet
supplied).
Use a flat-head screwdriver to
set rotary switch
External Power
(TPD-280/283U-Mx only)
service@icpdas.com
PoE Switch
(TPD-283/283U-Mx only)
P4
Advertisement
