Advertisement
4
First Use of the TPD 2.8" H Series
GND
)
VDC (+12-+48 V
External Power
2. Supply power to the TPD-283-H/283U-H, wait for
several seconds and then you can see the default
program run on it.
3. Try to touch on the icons on the bottom-right corner
of the screen of the TPD-283-H/283U-H and you can
find that TPD-283-H/283U-H switches to the setting
pages.
5
Hardware Installation
External Wall Box, EWB-T28 (optional)
Technical support:
1. Connect wires as the figure or prepare an
Ethernet cable which will be used to supply
power through PoE if there's a RJ-45 Ethernet
port on it. And set the rotary switch to 0 (At this
point, the power is not yet supplied).
Use a flat-head screwdriver to set rotary switch
service@icpdas.com
PoE Switch
Outlet Box, OB120 (optional)
P4
Advertisement
