ICPDAS TPD Mx Series Quick Start Manual page 3

3
Rotary Switch & Default Settings
The definition of the rotary switch (TPD-280-Mx):
No Mode
0 Run Only
1
Update Only This mode is used for updating programs.
The definition of the rotary switch (TPD-283-Mx):
No Mode
Run &
0
Update
Force
1
Update
Run Only
2
The definition of the rotary switch (TPD-283U-Mx):
No Mode
Run &
Update
0
(Ethernet)
Ethernet
Force
1
Update
Run Only
2
USB Force
9
Update
Network Default Settings (TPD-283/283U-Mx):
IP Address
Subnet Mask
Gateway
Technical support:
Description
Run the program. (Default)
Description
Run or update the program. This mode is
used in the development phase. (Default)
While the application run on the TouchPAD
device seriously crashes, use this mode to
update a new application to the TouchPAD
device through Ethernet.
Run the program.
Description
This is a special run mode which is used in
the development stage. The TouchPAD
device can be updated by a PC from the
remote side through Ethernet. (Default)
While the application run on the TouchPAD
device seriously crashes, use this mode to
update a new application to the TouchPAD
device through Ethernet.
Run the program.
Update a new application to the TouchPAD
device through USB.
192.168.255.1
255.255.0.0
192.168.0.1
service@icpdas.com P3