Table of Contents
Advertisement
PLUMBING TO AN RO UNIT
Refer to the instructions on how to use the Buddie Fit press fittings before installing the tubing.
Step 1 – Cut the blue tubing as needed. Connect one end of the blue tubing to the clean water exiting a
Reverse Osmosis filtration unit.
Step 2 – Connect the other end of the blue tubing to the port on the right side of the DI Filtration Unit
(Labeled "Supply").
Step 3 – Use a second piece of the blue tubing to route the water from the left port of the DI Filtration
Unit to the desired water collection point.
UNIT MAINTENANCE
The Aquatic Life Deionization Cartridges are designed to change color when the resin inside is
exhausted. When the entire cartridge has changed color, it is time to replace the cartridge.
Reorder Aquatic Life Item # 330091, UPC # 810957010911
Models 540501 & 540503 Only - To get the most benefit out of each cartridge we recommend replacing
one cartridge at a time to allow the resin in the second cartridge to completely exhaust/deplete.
OPERATION & CONSIDERATIONS
Refillable clear canisters have a limited life and should be replaced on an annual basis to prevent
possible failure.
Operating pressure greater than 80 PSI may require a pressure regulator.
With initial operation, check for leaks. If a leak is observed, verify that the tubing is pushed into
the push-fitting far enough to seal the tubing against the O-ring and that the canisters and caps
are sealed properly with their O-rings.
Many of the components in the DI Unit are plastic and subject to damage by ultraviolet light.
Never store or operate the unit in direct sunlight or other bright lights.
Do not store or operate the unit in temperatures above 100°F.
Do not store or operate the unit in freezing temperatures.
Do not leave the unit unattended while connected to a water supply.
Advertisement
Table of Contents
