Wired Probe System - Troubleshooting Guide
Introduction
Wired Probe System - Troubleshooting Guide
Page 1 of 7 pages
1. OMP40 work probe: A spindle-mounted
wireless probe that communicates with
an optical interface.
2. Work probe stylus: The part of the work
probe that touches parts during
measurement.
3. Tool probe stylus: The part of the tool
probe that tools touch during
measurement. Tools touch the top and
side of the stylus when the probe
measures tool length and diameter.
4. TS27R tool probe: The table-mounted
TS27R has no batteries or optical
interface. This is a wired probe.
5. Tool probe cable: This cable carries
signals from the tool probe to the CNC
control.
6. OMI Optical Machine Interface: The
wireless interface for the OMP40 work
probe. The OMI uses infrared light to
communicate with the CNC control and
switch the probe on or off.
7. OMI cable: This cable connects the OMI
to the CNC control.
Work probes for Wireless Probe System (WIPS) do
not work in the wired probe systems (VQCPS).
• The VCQPS work probe (P/N 60-0024)
has a square Haas logo.
• The WIPS work probe (P/N 60-0050) has
a round Haas logo.
LAST UPDATED: 02/14/2020