Advertisement
Wired Probe System - Troubleshooting Guide
Settings
Corrective Action:
A procedure to verify the probe settings is included in the Renishaw Probes Installation guide. Refer to
RENISHAW PROBES -
INSTALLATION.
Note: Do not touch the stylus when you install the batteries. This can change the settings.
To change the probe settings you move the stylus in a specified order. Refer to the illustration to see the specified
order.
THE ILLUSTRATION SHOWS THESE
SYMBOLS:
A red arrow that points to the right.
A green arrow that points down.
A white arrow that points down.
THE SYMBOLS TELLS YOU THIS:
Move and hold the stylus for less than (4)
seconds.
Move and hold the stylus for more than (4)
seconds.
Do not touch the stylus for (20) seconds or
more.
Page 6 of 7 pages
MILL -
THIS GIVES THIS RESULT:
Selects the next option within a
group.
Moves from one group to another.
Exits the set up.
Advertisement
