Atapi Devices - ELBOX Fast ATA 1200 MK-IV User Manual

Then, use only the filesystems with NSD, TD64 or DirectSCSI
commands implemented.
Note: Run AT A3.driver before partitioning HDDs larger than
4 GB!
Note: Some filesystems (e.g. FFS) don't support correctly
partitions larger than 2 GB.
>
If same of HDD is not validated ata3.driver will stop running until
Amiga will finish validating this HDD.
Note: The controller without software installed operates
only with the PRIMARY PORT, in exactly the same
way as a standard A1200 controller.
ATAPI DEVICES
>
If you have ATAPI-standard devices installed, the Devs/DOSDrivers
folder has to include an appropriate mountlist.
Note: You can make use of the CDO mountlist included in
the STORAGE disk of Workbench 3.1. The Unit
parameter of the CDO mountlist shall correspond to
the Unit number for the given CD-ROM drive:
PRIMARY MASTER UnitO
PRIMARY SLAVE Unit 1
SECONDARY MASTER Unit 2
SECONDARY SLAVE Unit 3
Note: CDx mountlists for AllegroCDFS are stored in
FastATA'99:mountlists folder
Note: If you are using any other mountlist, always set the
device=scsi. device for HDD, CD-ROM, CD-R, CD-
RW drives and device=trackdisk.device for
removable media like LS-120, ZIP-ATAPI.
>
Removable media drives like LS-120, ZIP ATAPI, etc., when
formatted with the Amiga operational system, do not require a special
mountlist as they are automatically recognised.
>
When these media are used in the PC format, the Devs/DOSDrivers
folder has to include an appropriate mountlist (PCx).
12