Table of Contents
Advertisement
Installation Steps
Note: Steps 1 – 7 are independent, and can be performed in any order.
Step 2: Installing the Drinking Water
Faucet
2.1 If your kitchen sink does not have an existing ½" hole,
you will have to drill one. (Refer to How to drill a Hole
on Sink or Counter-top). Wipe clean and dry the area.
2.2 Slip the front plate on the faucet stem, followed by the
rubber washer. Insert the faucet stem into the hole on
countertop
2.3 Under the sink, slip on the back rubber washer, tighten
the nut with plastic wing.
2.4 Screw the tubing adapter on to the faucet stem. Insert the
BLUE
tubing 1/2 inch deep into the Push-in fitting.
Page 7
Step 1: Installing the Feed Water Adapter (AFW)
1.1 Turn off the Cold Water Line via the Cold Water Shutoff Valve (CWSV) under
the sink. Open the kitchen faucet to release pressure and make sure water has
stopped before proceeding to the next step. Get a towel or bucket to catch water
spill. Disconnect Kitchen Faucet Connector (KFC) pipe from CWSV.
1.2 Check O-ring inside AFW female end, and twist it onto CWSV. Tighten it up
using wrench or pliers.
1.3 Twist KFC onto the male end of AFW. Turn the handle of AFW to cross (OFF)
position. Turn on CWSV slowly, check and fix any leaks.
1.4 Connect the 1/4"
www.purifiltration.com
RED
tubing to AFW.
| (678) 900-4702 |
support@purifiltration.com
Advertisement
Table of Contents
