VentMed CPAP User Manual page 5

User Guide
CAUTION
Do not overfill the water tank as water may enter the device and air
tubing.
1. Place the device on a stable level surface.
2. Plug the power connector into the rear of the device. Connect one end of the
power cord into the power supply unit and the other end into the power outlet.
3. Connect the air tubing firmly to the air outlet located on the rear of the device.
4. Open the water tank cover and fill it with distilled water up to the maximum
water level mark. Do not fill hot water in the water tank.
5. Close the water tank cover.
6. Connect the free end of the air tubing firmly onto mask. For detailed
information, read the mask user guide.
7. Physician should ensure the compatibility of the equipment and all of the parts
and accessories used to connect to the patient before use; should ensure that the
therapeutic pressure settings were determined for the patient individually with
the configuration of the equipment to be used, including accessories; and should
4